Skateboard bearings sit between the axle and the wheel. They are small parts, but the right size, correct installation and basic care matter more than a headline about speed.
Start with fit and quantity
Most skateboard wheels use the common 608 bearing size. Check your wheel or equipment details if your setup is unusual, and confirm the size on the product page before you buy. A standard four-wheel skateboard commonly uses eight individual bearings. Count the bearing positions in your setup and compare that number with the pack count shown on the DSCO listing.
Compare the details that are listed
Look at pack quantity, shields, spacers, materials and any included parts. These details vary between products, so do not assume that a tool, spacer or washer comes with every set. DSCO’s bearing comparison summarises the current listings. Open the individual product page to confirm full contents, price and availability.
ABEC is one detail, not a shortcut
ABEC describes a set of manufacturing tolerances. It is not a complete measure of skateboard speed, durability or suitability. Wheel setup, installation, lubrication and care also affect how the complete setup feels. Read the ABEC 5 vs ABEC 7 guide before comparing ratings.
Install and care for the whole setup
Press bearings evenly into the wheel and avoid forcing parts that do not line up. After installation, check that each wheel spins freely without excessive side-to-side movement. Keep bearings dry, clear grit before adding lubricant, and follow the product instructions for cleaning and lubrication. If a bearing remains rough or damaged after sensible care, replace it.
Still unsure about fit? Send DSCO a setup question with your wheel or equipment details before ordering.